- Flow rates designed on temperatures of 25°C or 77°F
- Polyurethane coated steel or stainless steel frame
- Stainless steel high pressure Booster Pump with TEFC Motor
- Stainless steel prefilter housing with a maximum operating
pressure of 150psi
- 5 Micron prefilter pleated cartridges
- 2” 3 Way Control Valve with 1/8 inch Solenoid for inlet and automatic flush
- Pressure Gauges Stainless steel oil filled
Prefilter 0 – 100 psi Post Filter 0 – 100psi
Product 0 – 100 psi Pump 0 – 600psi
Waste 0 – 600psi Module 0 – 600psi
- Flow Controls for product, waste and recycle.
- Waste recycle reduces waste water cost by up to 80 percent
- Low feed pressure switch
- High pump pressure switch
- Reverse Osmosis tank level switches
- Product water TDS/conductivity meter
- Reverse Osmosis tank full override
- Operating temperature of 22°F to 140°F
- 8”x40” fiberglass filament wound or stainless steel membrane
housing with/end caps
- 8”x40” low energy thin film composite membranes
- All plumbing will be high pressure Sch80 PVC pipe and fittings
- MICROPROCESSOR CONTROLLER STANDARD FEATURES:
- Universal AC Power 80 – 265 Vac 50/60 HZ
- 4 Lines x 40 Character backlit liquid crystal display
- 18 Key keypad with integral alarm light
- Programmable time delays and set points
- Real time clock with battery backup
- Non- volatile set point memory
- Audible alarm with timed alarm silence
- US or Metric readings
- Nema 4X hinged enclosure, 16”x14”x8”, larger panel required
- Plug in terminal strips
- Led input/output indicators
- Pre-programmed R.O. functions
- MICROPROCESSOR CONTROLS AND MONITORS THE FOLLOWING:
- Feedwater valve relay
- Reverse Osmosis and Auxiliary pump control relays
- Permeate and feed TDS/Conductivity membrane flush valve relay
- Permeate divert valve relay temperature
- Operating hours
- Low feed pressure switch
- High pump pressure switch
- Pretreatment lockout
- Flow meter interface for permeate and concentrate
- Reverse Osmosis tank switches
- Reverse Osmosis tank low switch
- Remote alarm output
- RS232 serial port output
- OPTIONS:
- pH sensors with display and alarms set points
- IEC motor starters and control transformers flow sensors to display
flow in GPM or LPM with percent recovery displayed and alarm set
points for high and low flow rates
- Pressure sensors allowing display on LCD of pressures and differential pressures with programmable set points for high, low with differential pressure alarms
- Graphic display
|
